MST32 CAN connects the CAN fieldbus with MST32 modules and supports all CAN baud rates up to 1 MBaud.
The MST32 CAN module can be used in two ways:
a) as an MST32 module bus master
b) as an MST32 module bus slave
In the case of a), a passive bus coupler is used for up to 64 MST32 modules. MST32 CAN must be the second module after the power adapter and only one MST32 CAN module is allowed.
The bus coupler recognizes the connected module upon starting, automatically creates a configuration and organizes the in- and outputs of the I/O module to the process image data.
In the case of b), an MST32 module bus master, such as CPU-ETH, must be located to the left of the power adapter. MST32 CAN recognizes its bus activities and works as a module bus slave. The module bus master sends its CAN configuration data, and in this configuration it is possible to line up multiple MST32 CANs.
Sending and receiving activity is signalized using LEDs.
[This module is currently only available with dresden electronic specific firmware for dynamic signposting!]
Accessories
SubCon Plus Plug of by Phoenix 2744694 (recommended, not included) (Article no.18025)
MST32 CAN connects the CAN fieldbus with MST32 modules and supports all CAN baud rates up to 1 MBaud.
The MST32 CAN module can be used in two ways:
a) as an MST32 module bus master
b) as an MST32 module bus slave
In the case of a), a passive bus coupler is used for up to 64 MST32 modules. MST32 CAN must be the second module after the power adapter and only one MST32 CAN module is allowed.
The bus coupler recognizes the connected module upon starting, automatically creates a configuration and organizes the in- and outputs of the I/O module to the process image data.
In the case of b), an MST32 module bus master, such as CPU-ETH, must be located to the left of the power adapter. MST32 CAN recognizes its bus activities and works as a module bus slave. The module bus master sends its CAN configuration data, and in this configuration it is possible to line up multiple MST32 CANs.
Sending and receiving activity is signalized using LEDs.
[This module is currently only available with dresden electronic specific firmware for dynamic signposting!]
Accessories
SubCon Plus Plug of by Phoenix 2744694 (recommended, not included) (Article no.18025)
| Technical data |
|---|
| Dimensions | W x H x D 22.5 X 99 X 114.4 mm |
| Installation | Top-hat rail NS 35 |
| Weight | 110 g |
| Operating temperature | -25°C ... + 55°C without condensation |
| IP protection | IP20 |
| Supply | Via module bus |
| Connections | D-Sub socket 9 pin (CAN Standard DS102) |
| EMC | Susceptibility according to EN 61131-2:2003
Interference emission according to EN 61131-2:2003 |
| Bit width in process image | 0 .. 255 Byte input/output depending on configuration
iin 4C MST32 configurator inputs |
| CAN | Transmission medium: insulated copper cable 2 x 2 x 0.5 mm²
Transmission rate: 1 MBaud, 800, 250, 125, 100, 50, 20, 10, 5 KBaud
max. segment length: 40 m .. 1000 m depending on Baud rate |
